Home > Gun Type > AK Products > AK Scope Mounts > AK 47/74 Optic Mount > Gen 2 >

MI-AKSMG2-A
Gen 2 Side Mount ACOG

MI-AKSMG2-A<br>Gen 2 Side Mount ACOG


 
Alternative Views:


Our Price: $159.95

Stock Status:(Out of Stock)

Product Code: MI-AKSMG2-A
Qty:

 
  • Attaches to AK rifles with standard AKM receiver rail interface
  • Puts optic on center or extremely close to center of the top cover on mil-spec built AK rifles
  • Modular top piece allows the top to be changed to a different configuration later if desired
  • Constructed from hard coat anodized 6061 aluminum
  • Feature the patented Elite Defense QD system for no tool adjustment and repeat zero locking
  • Weight 7 oz
  • 100% Made in U.S.A., with MI Lifetime Warranty

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 4 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 So far, so good February 4, 2020
Reviewer: Anonymous Person  
Bought this to use on a PSA GF3 with a Primary Arms 3x Prism optic. The scope is centered perfectly over my top cover, and everything has held zero after 150 ish rounds and several test runs of the QD system.

Only time will tell if this mount holds up in the long term, but so far, so good.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 ACOG Mount w/ Burris September 16, 2019
Reviewer: Joe from North Chesterfield, VA United States  
I'm using this mount with a Burris AR-332. Optic fits perfectly in the mount and the base locks very tightly to the rail. I put Locktite on the optic mounting screws but not the upper and lower sections of the mount so it started to work itself apart after a few mags but that's my bad. Dabbed the hex screws with some blue juice and it's still solid more than a thousand rounds later. The mount also returns to zero very well.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Works Great February 28, 2019
Reviewer: Adam from TX United States  
Seems to be very sturdy and consistently maintain the zero on my scope when I remove it from my rifle.  Purchased this for a PSA GF3, its dead center over the bore and mounts low to the rifle.  Running a PA 3x ACSS, it provides the exact eye relief needed with my check weld on a factory stock.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Perfect single piece ACOG mount September 4, 2018
Reviewer: Mark from Cape Coral, FL United States  
Used this setup to mount a Primary Arms 3X on to a Romanian RH-10. Was able to attach the scope directly and securely onto the mount. Lines up almost dead center bore and sets low, just above the dust cover. Removes easily and holds zero when re-attached.....very pleased.

Was this review helpful to you?